Tag Archives: instructions
How to Install Agency Power Cold Air Intake VW Golf GTI MK7 | Audi A3
This Install Guide is intended to help with the installation of Agency Power Part# AP-MK7-110 Level of difficulty Step 1. Remove the small vacuum line located on the side of the factory airbox Step 2. Pinch the sides of the plastic connector and pull away from the airbox to remove… Read More
How to Install the Agency Power Mercedes CLA 250 Intercooler
This guide is to help with the installation of the Agency Power Intercooler Upgrade for the Mercedes CLA250. Begin by taking out all the bolts and clips that connect the under tray to the front bumper. Unclip the wheel well lower bumper clip and 2 x 10mm bolts behind the wheelwell to allow… Read More
Can-Am Maverick X3 Turbo Upgraded Intercooler Installation
This guide is to help with the installation of the Agency Power Upgraded Intercooler for the Can-am Maverick X3 Turbo | DS | RS & RC Estimated Install time: 30-45 min Step 1: Remove the intake and intercooler plastic covers from the rear of the X3. Step 2: Remove the two 2x… Read More
BMW M2 | 335i | 435i | M235i Intercooler Installation
The Agency Power upgraded intercooler kit for the BMW F22 F87 F30 F32 N55 car is very easy to install. It is a direct replacement and can be swapped in under an hour. Start your installation by lifting the car and removing the front wheels. Then pull out the inner fender liner… Read More
Honda Civic SI FC3 / FC1 Intercooler Installation
The installation of the Agency Power Honda Civic FC3 / FC1 intercooler is a very straight forward remove and replace. The intercooler is designed a full OEM replacement utilizing factory hose and sensor connections. The intercooler is slightly taller with an additional row for more capacity to cool. Start off your installation by… Read More
How to Install the Ford Mustang EcoBoost Intercooler
The new Ford Mustang EcoBoost intercooler is a must have to bring those temperatures down and the efficiency of the 2.3L turbo up! Installation is not difficult and major cutting is not required. What the intercooler looks like: Installation is a simple remove and replace of the factory intercooler. Once all the… Read More
