Tag Archives: Installation
Agency Power Upgraded Camshafts Installation for the Can-Am X3
We hope you have found this link as a new purchaser of our Camshafts for your Can-Am Maverick X3 Turbo. These are a direct drop in and will take you about 6 hours to do the install with the proper tools. These installation steps are showing you what was done to swap… Read More
How to Install Agency Power Cold Air Intake VW Golf GTI MK7 | Audi A3
This Install Guide is intended to help with the installation of Agency Power Part# AP-MK7-110 Level of difficulty Step 1. Remove the small vacuum line located on the side of the factory airbox Step 2. Pinch the sides of the plastic connector and pull away from the airbox to remove… Read More
How to Install the Agency Power Mercedes CLA 250 Intercooler
This guide is to help with the installation of the Agency Power Intercooler Upgrade for the Mercedes CLA250. Begin by taking out all the bolts and clips that connect the under tray to the front bumper. Unclip the wheel well lower bumper clip and 2 x 10mm bolts behind the wheelwell to allow… Read More
Can-Am Maverick X3 Turbo Upgraded Intercooler Installation
This guide is to help with the installation of the Agency Power Upgraded Intercooler for the Can-am Maverick X3 Turbo | DS | RS & RC Estimated Install time: 30-45 min Step 1: Remove the intake and intercooler plastic covers from the rear of the X3. Step 2: Remove the two 2x… Read More
Can-Am X3 Turbo Intake Instructions
This guide is to help with the installation of the Agency Power Can-Am Maverick X3 Turbo Intake. STEP 1 – Remove the plastic intake cover, intercooler vent, and engine access cover. STEP 2 – disconnect the breather hose from factory air box. STEP 3 – Loosen the hose clamps on the intake… Read More
BMW M2 | 335i | 435i | M235i Intercooler Installation
The Agency Power upgraded intercooler kit for the BMW F22 F87 F30 F32 N55 car is very easy to install. It is a direct replacement and can be swapped in under an hour. Start your installation by lifting the car and removing the front wheels. Then pull out the inner fender liner… Read More
