Tag Archives: install guide
How To Install Agency Power Rear Bulkhead Support Links On Can-Am X3
In this guide, we will be going over the step-by-step instructions on how to install the Agency Power rear bulkhead support links. Note: The bulkhead supports only work with the Agency Power radius rods or 5/8th heim joints. Installation Difficulty: Estimated Install Time: 45 minutes Tools Needed: 3/8th Ratchet 18mm socket Floor… Read More
Agency Power Can-Am X3 Interior Kit Installation Guide
In this guide, we will be going over the installation process of the Agency Power interior kit step-by-step on your Can-Am Maverick X3. Installation Difficulty: Estimated Install Time: 45 minutes for the whole kit Tools Needed: Electric Drill With 5/32nd Drill Bit 3/8th ratchet HW4 Bit – 4mm Allen 13mm Wrench Scribe… Read More
Agency Power Can-Am X3 Door Spring Kit Installation Guide
This is a step-by-step guide on how to install the Agency Power door spring kit on your Can-Am Maverick X3! Installation Difficulty: Estimated Install Time: 15-20 minutes per door. Tools Needed: 3/8 Ratchet 13mm Socket T-30 Torx Bit HW4 Bit – 4mm Allen Key HW5 Bit – 5mm Allen Key Front Doors Installation… Read More
How To Install Agency Power Tow Hitch On Your Can-Am X3
With our quick install guide you will be able to replace the factory radius rod plate with the Agency Power tow hitch for your Can-Am Maverick X3. The tow hitch is an excellent tool for pulling a small trailer or using various hitch attaching accessories while also stiffening up the radius rods.… Read More
How to Install Agency Power Cold Air Intake VW Golf GTI MK7 | Audi A3
This Install Guide is intended to help with the installation of Agency Power Part# AP-MK7-110 Level of difficulty Step 1. Remove the small vacuum line located on the side of the factory airbox Step 2. Pinch the sides of the plastic connector and pull away from the airbox to remove… Read More
How to Install Agency Power Race Pipe Can-Am Maverick X3 Turbo
How to Install Agency Power Race Pipe on the Can-Am Maverick X3 Turbo This guide is to assist with the installation of the Agency Power Race Pipe on the Can-Am Maverick X3 Turbo. Estimated Installation time: 30-60 minutes Recommended Tools for Installation: 3/8 or 1/4 ratcheting wrench with extensions 8mm socket 10mm… Read More
