Tag Archives: AP
How To Install Agency Power Cold Air Intake System On Kia Stinger GT
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake System on the 2018 – 2019 Kia Stinger GT with 3.3L TT V6. A PDF of these instructions can be found HERE Unbolt 2 bolts holding cross support bar on driver then repeat on passenger side.… Read More
How To Install Agency Power Cold Air Intake System On BMW M3 / M4
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2015 – 2018 BMW M3 F80 / M4 F82/F83. Trimming is required for proper intake fitment. Agency Power recommends custom calibration to prevent check engine lights. INSTALL DIFFICULTY: Remove carbon fiber strut… Read More
How To Install Agency Power Honda Civic Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Honda Civic. Install Level: Unclip and unbolt the car underbody shields. Unbolt the 3 flange bolts. Carefully remove the factory exhaust from the hanger bushings. And lower the factory exhaust off the car. With factory system removed. Install… Read More
How To Install Agency Power Mazda Miata Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Mazda Miata. Install Level: Step 1: Remove the rear muffler section of your factory set up. Undo the 2 bolts and carefully remove hangers. You will reuse the rubber hanger bushings do not damage, Step 2: Remove 4 bolts… Read More
How to Install Agency Power Catback Exhaust System for Porsche 718 Boxster / Cayman
This guide is to help with the installation of the Agency Power Catback Exhaust for Porsche 718 Boxster and Cayman. Install Level: Step 1 – For easier access remove the rear wheels. Step 2 – Remove the 2 Bolts on the over axle pipe flange. Repeat on each side. Step 3 – Remove… Read More
How to Install Agency Power Cold Air Intake System on Subaru STI
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2015-17 Subaru STI. INSTALL DIFFICULTY: STEP 1 – Remove Scoop by unhooking the 3 clips holding scoop. And carefully remove scoop. STEP 2 – Un-clip the mass air flow sensor harness. STEP 3… Read More
