Tag Archives: Agency
How To Install Agency Power Mazda Miata Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Mazda Miata. Install Level: Step 1: Remove the rear muffler section of your factory set up. Undo the 2 bolts and carefully remove hangers. You will reuse the rubber hanger bushings do not damage, Step 2: Remove 4 bolts… Read More
How to Install Agency Power Catback Exhaust System for Porsche 718 Boxster / Cayman
This guide is to help with the installation of the Agency Power Catback Exhaust for Porsche 718 Boxster and Cayman. Install Level: Step 1 – For easier access remove the rear wheels. Step 2 – Remove the 2 Bolts on the over axle pipe flange. Repeat on each side. Step 3 – Remove… Read More
How to Install Agency Power Cold Air Intake System on Subaru STI
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2015-17 Subaru STI. INSTALL DIFFICULTY: STEP 1 – Remove Scoop by unhooking the 3 clips holding scoop. And carefully remove scoop. STEP 2 – Un-clip the mass air flow sensor harness. STEP 3… Read More
How To Install Agency Power Infiniti Q50 Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Infiniti Q50. Install Level: STEP 1 – Unbolt the 4 factory bolts from down-pipes to X-pipe. STEP 2 – Unbolt the 4 factory bolts from mid-pipes to the muffler. Remove the hangers from bushings on the factory muffler… Read More
How to Install Agency Power Cold Air Intake System on Subaru BRZ / Scion FR-S / Toyota 86
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2013-18 Subaru BRZ / Scion FR-S / Toyota 86. INSTALL DIFFICULTY: STEP 1 – Unclip the Mass Air Flow Sensor Harness and then loosen the 2 screws. Remove the Mass Air Flow Sensor.… Read More
How to Install Agency Power Catback Exhaust System on Ford Focus RS
This guide is to help with the installation of the Agency Power Catback Exhaust for Ford Focus RS. Install Level: STEP 1 – Locate the OEM Exhaust valve module at the rear of the exhaust system next to the driver side exhaust tip. Disconnect the valve and remove the 3 nylon locking nuts… Read More
