Up-Close Look at the Agency Power Mercedes-Benz 45AMG Blow-off Valve
The Mercedes 45 AMG 2.0L turbocharged engine proves itself making over 400 horsepower with simple mods like an exhaust system and ECU tune. With added boost pressure, you will notice your AMG 45 have an increase in compressor surge. Compressor surge is caused from the buildup of boost pressure in the charge… Read More
McLaren 540c With New Agency Power Rear Carbon Fiber Wing Installed!
Our friends over at McLaren Mexico just added the Agency Power Rear Carbon Fiber Wing to this stunning McLaren 540c. The Agency Power Rear Wing for the 570s & 540c features a lightweight 67″ APR Carbon Fiber Air Foil that matches the factory McLaren Carbon. The CNC Machined uprights were designed and… Read More
How to Install Agency Power Premium Front Grille on Can-am X3 | X3RS | X3DS
How to Install the Agency Power Premium Front Grille on Can-am X3 | X3RS | X3DS Tools Required for installation 5mm Allen Wrench 10mm Open End Wrench Estimated Install Time: 15-20 min Step 1: The OEM front Grille is only held in place by push clips. Pull outward on the grille to… Read More
How to Install Agency Power Valvetronic Exhaust Polaris RZR XP Turbo & XP4 Turbo
Installation overview of the Agency Power Valvetronic Exhaust System for the Polaris RZR XP Turbo & XP4 Turbo. PDF Version of these instructions available HERE Removing the factory muffler. Please Note: If your Polaris RZR is equipped with an aftermarket bumper/cage, removal of it may be required for installation. Step 1: Remove… Read More
Agency Power High Clearance Rear Arms Polaris RZR Install
Install overview of the Agency Power High Clearance Arms on the Polaris RZR XP 1000 & XP Turbo. Step 1) Before getting started, jack up the rear of the RZR and secure with jack stands. Remove both rear wheels to make the installation easier. Step 2) Loosen and remove the four… Read More
Agency Power Motor Mount Kit Install Polaris RZR 1000
How to Install the Agency Power Motor Mount Kit on the Polaris RZR XP | XP4 1000 Step 1: Starting on either the driver side or passenger side, remove the two 13mm nuts located on the underside of the motor mount. Step 2: Next support the engine mount bar by using… Read More
