How to Install Intake Manifold Spacer Ford Focus RS
This guide is to assist with the installation of the Agency Power Intake Manifold Spacer on the Ford Focus RS.
Always refer to vehicles service manual for torque specifications on OEM hardware.
Parts included:
1x Agency Power Intake Manifold Spacer
1x Replacement Genuine Ford Gasket kit
5x Extended Replacement Manifold Hardware
Step 1) Remove Engine Cover by lifting upwards to release from rubber grommets.
Step 2 ) Using a 10mm socket with extension, remove the 5 bolts in-between the intake runners that connect the manifold to the head.
Step 3 ) Insert and evenly seat the supplied replacement OEM Ford Manifold Gaskets into the machined groove of the Agency Power Manifold Spacer. See photos below.
Step 4 ) Gently pull back on the manifold (Towards Radiator) to create a gap between the manifold and engine. Insert the new Agency Power Manifold Spacer and align the aluminum dowel pins into place. Make sure the OEM Gaskets on both the Manifold & Spacer are seated properly and did not fall out or get smashed during this process. It may be necessary to have a friend help during this step.
Step 5 ) Use the supplied extended manifold hardware and evenly tighten the hardware starting with the middle bolt and then working your way out, side by side. Refer to vehicles service manual for torque specifications on OEM hardware.
Step 6 ) Replace the engine cover and enjoy 🙂