How to Install Agency Power Aeroform Side Skirt Extensions
This DIY guide will help guide you with the installation of the Agency Power Aeroform Side Skirt Extensions.
STEP 1: Jack up and support the car using jack stands. You will need to have plenty of clearance under the side skirt in-order to remove them. Please do not attempt to work under any vehicle without properly securing it with jack stands. Please refer to your owners manual if you are unsure where to lift and support the vehicle.
STEP 2: Remove the 11 Torx scews that run under and along the side skirt.
STEP 3: Once you have removed the screws you can now remove the side skirt. The skirt is held on using plastic clips. To remove, firmly pull outward. Start from the back and work your way forward or vice versa.
STEP 4: Now that side skirt has been removed from the vehicle you will need to clean & prep both the side skirt and the New Aeroform Side Skirt Extension for install. Use a clean microfiber and wipe down the underside of the side skirt and the Aeroform Side Skirt Extension using a 50:50 mixture of isopropyl alcohol (IPA) and water. (use a cloth or blanket on the floor to avoid scratching the side skirt during this procedure)
STEP 5: Apply 6″ to 8″ strips of 3M double sided tape (Not included) along the underside of the factory side skirt. (use images for reference) Once finished DO NOT peel and remove the top layer of the double side tape just yet!
STEP 6: For this next step we will be mocking up the side skirt to the Aeroform side skirt extension and marking the holes that will need to be drilled. With the help of a friend, position and align the side skirt extension up to the side skirt. Use a marker and mark each hole. (Please refer to the images for reference)
STEP 7: Carefully drill each mark you indicated on step 6
STEP 8: Remove the top layer to expose the 3M double side tape and apply the Aeroform side skirt extension to the factory side skirt. Make sure you are lined up exactly to the holes that have just been drilled. We have included both short and longer bolts. Use the longer hardware for the rear of the side skirt and the short hardware for the front. It is very important not to mix these up or the side skirt will not slide into place when you got to reinstall the side skirt back on to the vehicle. Please use the image provided below for reference.)
STEP 9: Now that the Aeroform Side Skirt extension is bolted on to the factory hardware you can now reinstall the side skirt back onto the vehicle.
STEP 10: Repeat steps 1-9 for the other side of the vehicle. Once finished step back and enjoy the new look of your Agency Power Aeroform Side Skirt Extensions!