How to Install Agency Power Aeroform Front Lip | BMW F80 M3 & F82 M4
This DIY guide is intended to help with the installation of the Agency Power Aeroform Carbon Fiber 3 Piece Front Lip for BMW F82 F80 M4 M3 15-16
The following is recommended for install:
- 3M Automotive Double Side Tape
- 8mm socket/nut driver
- hex/Allen wrench set
- 50:50 isopropyl alcohol and water
- Friend to assist
PLEASE NOTE* Be very careful not over tighten any screws that attach the carbon fiber pieces. You will crack the carbon! This is not covered under warranty!
STEP 1: Jack up and support the car using jack stands. This will give you plenty of room for the installation procedure. Please do not attempt to work under any vehicle without properly securing it with jack stands. Please refer to your owners manual if you are unsure where to lift and support the vehicle.
STEP 2: Remove the (4) 8mm screws located at the center of the front bumper
STEP 3: Remove both driver and passenger side plastic splash splash guards. We will be replacing these with the new Agency Power Aeroform replacements. Each side is secured with (7) 8mm screws. Use image below for reference.
STEP 4: Swap over the metal body retaining clips to the new Aeroform splash guards and re-install back onto the vehicle (Leave out the two outside screws. These will be used to secure the front lip to the bumper. See step #8 for reference)
STEP 5: Using the supplied hardware to attach both carbon blades to the front lip. (Leave hardware loose and tighten once it is installed on the vehicle. This will help make installation easier when fitting to vehicle)
STEP 6: Since we will be using 3m double side tape we will need to prep both the underside of the bumper and the Aerofrom Front Lip by wiping it down using a 50:50 isopropyl alcohol and water mixture. Make sure to use a clean microfiber to avoid scratching the carbon. After the surfaces are clean apply the 3m double side adhesive to the front lip. Use photos for reference
STEP 7: Peel back the red tape to expose the 3m tape. With the help of a friend carefully line up the front lip to the bumper. Make sure the holes line up bumper before sticking the lip to the car.
(If you have issues lining up you can separate the two carbon blades from the front lip and install them to the car separately)
STEP 8: Use the included longer screws to attach the front lip to the bumper. Replace the rest of the hardware that was left aside on step #4
You will need to use a 8mm open end wrench to get access to two the screws.
STEP 9: Step back and enjoy the new look of your BMW F8x with the Agency Power Aerofrom Carbon Fiber Front Lip!