How to Remove the OE Air Intake System from the BMW 335i|435i N55
Looking to install your new Agency Power Intake but not sure how to remove the OEM factory intake on your BMW 335i or 435i? We put together this step by step guide to help you out.
STEP 1
Undo the (4) metal straps located around the air intake box by just pulling back on the metal clips
STEP 2
Remove the vacuum line that is attached to the side of the intake tube. To remove squeeze the tabs on each side while simultaneously pulling on the tube.
Β STEP 3
Remove the mass air flow sensor located to the right of the Vacuum line you just removed. There is two torx bolts that hold the sensor in place.
STEP 4
Loosen the worm clamp on the intake tube.
STEP 5
Once everything has been disconnected and loose you can now Lift up the intake tube and pull it free from the center rubber mount.
STEP 6
Remove the intake box by lifting straight up. The box is only held in by two plastic dowel rods that sit snug in rubber mounts
STEP 7
Viola! Your now ready to install your new Agency Power intake! Need one? Click here to view product