How to Install the Agency Power Mercedes CLA 250 Intercooler
This guide is to help with the installation of the Agency PowerΒ Intercooler Upgrade for the Mercedes CLA250.
Begin by taking out all the bolts and clips that connect the under tray to the front bumper.
Unclip the wheel well lower bumper clip and 2 x 10mm bolts behind the wheelwell to allow the lower bumper to unsnap from the car.
Pull back hood trim seal which will allow access to bolts holding the top of the bumper in place.
With bumper unbolted and clipped carefully remove from vehicle.
As you pull bumper forward unclip harness.
With bumper removed you can now begin unclipping the intercooler cover and intercooler from the car.
Once the factory intercooler is removed set the new intercooler in place.
Bolt the intercooler to the factory supports. Leave loose until you have reconnected the tubes.
With piping connected tighten the bolts.
Reinstall the factory bumper by reversing the removal and you have completed installation.