How To Install Agency Power Weighted Shift Knob | Honda Civic Si
This Install Guide is intended to help with the installation of the Agency Power Weighted Shift Knob for 2017-2019 Honda Civic Si and Honda Shifters with M10x1.5.
Remove passenger and driver side center console trim pulling slightly up and toward rear of vehicle.
Unscrew the 2 screws holding shifter boot assembly.
Pull up to release latch and allow boot assembly to be free.
Carefully disconnect the 3 electrical connectors to allow shifter to rotate.
Unscrew shift knob counter clockwise to remove boot/ball and shifter assembly.
Cut the the zip tie securing the boot to the shift knob and remove knob.
Fold boot in half and go down from shifter ball hole till boot measures 2.25 inches across and remove the upper portion.
Insert the shift ball in place and zip tie. Cut off excess zip tie.
Screw in shifter ball and assembly.
Reconnect connectors.
Re-bolt the 2 screws back into place and install the trim pieces.
Push in the shift pattern insert into center of shift ball in correct orientation.
Install is complete.