In this guide, we will be going over the step-by-step instructions on how to install the Agency Power rear bulkhead support links.

Note: The bulkhead supports only work with the Agency Power radius rods or 5/8th heim joints.

Installation Difficulty:

Estimated Install Time: 45 minutes

Tools Needed:

• 3/8th Ratchet
• 18mm socket
• Floor Jack or Lift

Installation

Step 1: Jack up the rear of the machine to release tension off the radius rods.

Step 2: Remove the 6 bolts holding the radius rod plate on with an 18mm socket.

Step 3: Remove the radius rod plate and remove the arms.

Step 4: Place the bulkhead support links over the factory radius rod studs.

Step 5: Replace the factory radius rods with Agency Power radius rods.

Step 6: Re-install the radius rod plate and tighten down 6 bolts with an 18mm socket.