How To Install Agency Power Lightweight Under-Drive Crank Pulley on VW 2.0L TDI
This Install Guide is intended to help with the installation of the Agency Power Lightweight Under-Drive Crank Pulley on the Volkswagen 2.0L TDI Engine.
- 2015-201 Audi A3 (8P)
- 2015-2019 VW Golf 7 Sedan & SportWagen
- 2015-2019 VW Beetle
- 2015-2019 VW Jetta VI
- 2015-2019 VW Passat
Remove passenger side lower fender liner.
Using aΒ 16mm wrench rotate idler pulley bolt counter clockwise so belt tension allows to remove belt. Then carefully release tension.
UsingΒ a 10mm triple square remove the 4 bolts on the crankshaft pulley and remove pulley.
Check and clean the mounting surface and place pulley into position using the alignment holes.
Using the factory bolts re-install in a crisscross pattern to 7ft lb + additional 90 degree.
Install the new belt follow same steps as removal. Be sure the belt is seated properly in the pulley grooves.
Re-install fender liner.
Double check belt clearance and seating.
Installation is now complete.