This Install Guide is intended to help with the installation of the Agency Power Half Doors on a Mahindra Roxor.

Remove the 4 plastic screw rivets on the side of the Roxor with a phillips screwdriver.

Take one of the lower door hinge and use 2 bolts to loosely bolt into the exposed holes from the plastic screw rivets.

Add the compatible top hinge to the door frame. Put bolt into door hinge and frame tighten with nut. Leave slightly loose for alignment.

With the hinges secure. Slid the door onto the hinge for placement.

Line up the door into position. Tighten when you find the correct alignment.Close the door and mark the holes for the door latch bracket to allow for the latch to secure. Drill 2 holes on each side for mounting.

Bolt the bracket into position using the supplied nuts and bolts.

With a phillips screw driver you can loosen and adjust the door latch for proper alignment.

Tighten all bolts and repeat on the other side.

Congratulation you have installed the Agency Power Roxor Half Doors.