How to install Agency Power Carbon Fiber Porsche 997 Mirror Caps
How to install the Agency Power Porsche 997 Carbon Fiber Mirrors:
1. Remove the OEM mirrors. Just pop off this cover from the inside and undo the 3 torx bolts. Unclip the main connector and your mirror will come completely off.
2. Grab the mirror and lift off with some pressure and it will popoff to you. Then unplug its little connector. The stock mirror guts needs to be completely taken out. So undo all the little torx screws and unplug the mirror motor. Dont forget on the bottom of the mirror there is a screw too. Then the halves will slide apart.
3. Here are the new Agency Power carbon fiber mirrors ready for reassembly.
4. Slide the 2 halves on to the mirror posts. Dont do what I did and do the top and bolt everything together first! The bottom half and the harness must go on at the same time so the complete mirror is in place.
5. Now its all reassembly. You have to first put the torx screws on the mirror frame rods to the carbon pieces. Then you screw on the plastic base. Last step is to screw on the mirror motor. Once these are all screwed on, plug in the mirror motor from the harness you slid through the bottom half. Now that all the guts are installed, the halves should line up flush like the OEM piece. Place the mirror back on to the car and plug in the white round plug. Refit the 3 torx bolts. Now that the mirror is in place, you can plug in the mirror and push it back on.
Can the covers be removed easier by not removing from the car and disconnecting the two arms from the casing after taking out the guts first? Also, in your pictures it shows some over poor on edges surrounding where the mirror fits in, will that be present and needs to be cut off or is it finished off before being sent by the company? Larry
Hey Larry,
We apologize for the delayed response. Did you ever get the answer you needed? Is there anything else we can help you with?
Thank you for the comment.