This Install Guide is intended to help with the installation of the Agency Power Bypass Valve or Blow Off Valve on a Ford Focus RS.

1. Lift the car so you can remove the right hand side front wheel. Remember to secure the car before climbing underneath.
2. Find the factory bypass valve and unhook the vacuum line.
3. Unbolt the 3 bolts holding the valve in place and then remove the valve.
4. Before bolting in. Make sure the new valve is ready for install. Verify all bolts on top are tight. Along with the spring and plunger move freely.
5. Install the new valve where the factory was removed and reinstall using the 3 factory bolts.
6. Place the vacuum line on the new valve.
7. Reinstall the removed wheel and lower car down.
8. You have completed the install.