This Install Guide is intended to help with the installation of the Agency Power Boost Tap on a Volkswagen 1.8T/2.0T Golf GTi MK7, Beetle, Golf/GTI MK7, Jetta/GLI MK6, Passat B7 and Audi A3 8V.

1. Remove engine cover.

2. On the front of the intake manifold locate the boost sensor. Unbolt the T20 torx bolt and keep for reinstall.

3. Pull the boost sensor out from intake manifold by opening up retain clip.

4. Install the new boost tap into intake manifold using the factory T20 torx screw. **Do not over tighten manifold is plastic.**

5. Take the factory boost sensor and install into new boost tap. Tighten with the supplied M6 socket head screw.

NOTE: Attach vacuum line or cap fitting before running vehicle.

6. Reinstall your engine cover.

7. You have completed install of the boost tap.