How to Install Agency Power Billet Motor Mount Mercedes-Benz 45 AMG| CLA250 | GLA250 | A250
This guide is to help with the installation of the Agency Power Upgraded Billet Motor Mount for the Mercedes CLA45 AMG | GLA45 AMG | A45 AMG | CLA250 | GLA250 | A250 Models
For more info on this product click HERE.
STEP 1: For the installation of the Agency Power Motor Mount/Engine Support Mount you will need to support the engine. To do this start by securely lifting the vehicle using the proper lift points.
STEP 2: Remove the lower plastic splash guard by removing the (3) 8mm bolts.
STEP 3: Support the engine using a Jack and a piece of wood to evenly distribute the weight. You do not need to jack up the engine, you only need to support the engine.
STEP 4: Move to the top of the engine and Loosen and remove all (4) of the Torx bolts that secure the engine mount.
STEP 5: Slide the engine support bracket towards the front of the vehicle. This will give you enough room to now remove the engine mount from the vehicle.
STEP: 6 Install your new Agency Power Billet Engine Mount. Reverse the steps above for installation.
I have installed this engine mount on my mercedes 2015 A250. And the car has become extremely noisy in an unbareable way. It vibrates during idle and shakes heavily when i start it and there is always a grinding sound and even the engine sounds extremely noisywhile accelrating(not in a good way). I know that an aftermarket engine mount would be less comfortable but i didnt it expect it to be this noisy. I just wanna know now is this how it normally should be or was i sent a damaged or faulty product.
Sorry this was missed! If you haven’t already, please email us so we can remedy this issue. Sales@agency-power.com 1-480-921-7422
Bought one for my 2014 CLA250. Engine sound and exhaust note noticeably changed. Shifts are faster too with the engine moving less. But I’m getting very bad vibrations especially from the low end of the torque band. Also I notice that the product is 2 washers shorter in height vs OEM so I had to use washers. Had to bend the strut mounts slight to accommodate the AP mount. Please advise.
Sorry this was missed! If you haven’t already, please email us so we can address this concern Sales@agency-power.com 1-480-921-7422
did you find a solution to the vibrations?
The vibrations are normal when upgrading to stiffer engine mounts.
Can I install this mount without placing a jack support at the bottom? Planning to install this on my driveway which has a slight angle so would prefer not to jack up the car
You will need to jack up the car to unbolt the under tray and support the engine with the jack when you unbolt the engine mount. This product has been discontinued though. Please reach out to our sister company sales@vividracing.com and they can get you an equal or better quality mount.