How to Install Agency Power Air Intake Kit on the 2016+ Ford Focus RS
This install guide is intended to help with the installation of the Agency Power Air Intake Kit on the 2016+ Ford Focus RS.
Estimated Install time: 20 Minutes
Difficulty of Install: Easy
Tools required for install:
- 8mm socket or 8mm nut driver
- 7mm socket or 7mm nut driver
- Flathead screw driver (optional)
Step #1
Remove the engine cover by lifting upwards to free from rubber grommets.
Step #2
Remove the intake air box lid by loosening the (4) 8mm screws located on the outside edge of the airbox, lift up to remove cover from airbox.
Step #3
unconnect the the air sensor wire connector from the intake elbow.
Step #4
Remove plastic wire retaining clip on the intake elbow.
Step #5
Loosen the worm clamp on the intake boot.
Step #6
Remove screw on upper intake tube. This will make the removal of the lower intake elbow much easier.
Step #7
Remove OEM air filter from airbox.
Step #8
Remove the two screws holding the intake elbow to the OEM air intake housing.
Step #9
Remove the intake elbow from the vehicle.
Step #10
Remove the air senor from the intake elbow by twisting counter clockwise. Carefully pull to free sensor from elbow. (use photos for reference)
Step #11
Insert the air sensor into the new Agency Power intake elbow and turn clockwise to secure.
Step #12
Install the new Agency Power intake elbow into the airbox and reconnect the rubber intake boot.
Step #13
Install the Agency Power High Flow Air Filter into the airbox.
Step #14
Reverse the steps above from #8 – #1 to complete the installation of the Agency Power Air Intake Kit.