Category Archives: Technical Support
How To Install Agency Power Honda Civic Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Honda Civic. Install Level: Unclip and unbolt the car underbody shields. Unbolt the 3 flange bolts. Carefully remove the factory exhaust from the hanger bushings. And lower the factory exhaust off the car. With factory system removed. Install… Read More
How to Install the Agency Power Mercedes CLA 250 Intercooler
This guide is to help with the installation of the Agency Power Intercooler Upgrade for the Mercedes CLA250. Begin by taking out all the bolts and clips that connect the under tray to the front bumper. Unclip the wheel well lower bumper clip and 2 x 10mm bolts behind the wheelwell to allow… Read More
How To Install Agency Power Mazda Miata Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Mazda Miata. Install Level: Step 1: Remove the rear muffler section of your factory set up. Undo the 2 bolts and carefully remove hangers. You will reuse the rubber hanger bushings do not damage, Step 2: Remove 4 bolts… Read More
How to Install Agency Power Catback Exhaust System for Porsche 718 Boxster / Cayman
This guide is to help with the installation of the Agency Power Catback Exhaust for Porsche 718 Boxster and Cayman. Install Level: Step 1 – For easier access remove the rear wheels. Step 2 – Remove the 2 Bolts on the over axle pipe flange. Repeat on each side. Step 3 – Remove… Read More
Agency Power Motorsports Roll Install Porsche 991 GT3 RS
Installation of the Agency Power Motorsports 991 GT3 RS Bolt-in Roll Bar. This is not a guide, but a short overview of the installation. This pictorial shows the installation of the roll bar mounting brackets and roll bar.
How to Install Agency Power Cold Air Intake System on Subaru STI
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2015-17 Subaru STI. INSTALL DIFFICULTY: STEP 1 – Remove Scoop by unhooking the 3 clips holding scoop. And carefully remove scoop. STEP 2 – Un-clip the mass air flow sensor harness. STEP 3… Read More
