Category Archives: Technical Support
How To Install Agency Power Mercedes Benz G-Class Exhaust System Includes 4×4 Squared
This guide is to help with the installation of the Agency Power Exhaust for Mercedes Benz G-Class Including 4×4². Install Level: Find the 3 bolt flange connecting muffler to mid pipe on each side of the vehicle. Agency Power recommends spraying some penetrating oil on the bolts to allow for easier removal. Remove the… Read More
How To Install Agency Power VW GTi Mk7 Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for VW GTi Mk7. Install Level: Remove 4 bolts holding brace and put to side to be re-installed later. Unbolt factory slip fit clamp. Then push 3 hangers out of bushing to remove the factory system. Once removed… Read More
How To Install Agency Power Cold Air Intake System On Kia Stinger GT
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake System on the 2018 – 2019 Kia Stinger GT with 3.3L TT V6. A PDF of these instructions can be found HERE Unbolt 2 bolts holding cross support bar on driver then repeat on passenger side.… Read More
How To Install Agency Power Air Intake Polaris RZR 900S | 1000S
This Install Guide is intended to help with the installation of the Agency Power Air Intake System on the 2015-2019 POLARIS RZR 900S | 1000S. Remove engine cover. Unbolt the 4 bolts that hold the rear section of bed in place. Keep for re-installation. Agency Power recommends removing the seats for easier… Read More
Agency Power Carbon Fiber Dash Install 2019 Can-am Maverick X3
Agency Power Carbon Fiber Dash install & Trim guide for the 2019 Can-am Maverick X3 The 2019 Can-am X3 does not require the additional bracket needed like the the 17-18 models. Although slight trimming is required on the 2019 X3 models due to Can-ams recent update to the chassis. Step 1. Remove the four plastic clips and four T30… Read More
How To Install Agency Power Headers and Exhaust System Textron Wildcat XX
This Install Guide is intended to help with the installation of the Agency Power Headers and Exhaust System on the 2018+ Cold Air Intake Textron Wildcat XX. Remove rear tray and cover over exhaust to gain access for install, Un-clip the springs hold the factory muffler to the factory header. Unbolt and… Read More
