Category Archives: Technical Support
How To Install VR Performance Intercooler Upgrade On Kia Stinger GT
This Install Guide is intended to help with the installation of the VR Performance Cold Intercooler Upgrade on the 2018 – 2019 Kia Stinger GT with 3.3L TT V6. Click Here To View VR Performance Intercooler For Kia Stinger GT | Genesis G70 3.3L TT V6 Remove bumper by removing bolts from inside engine… Read More
How To Install Agency Power Weighted Shift Knob | Honda Civic Si
This Install Guide is intended to help with the installation of the Agency Power Weighted Shift Knob for 2017-2019 Honda Civic Si and Honda Shifters with M10x1.5. Remove passenger and driver side center console trim pulling slightly up and toward rear of vehicle. Unscrew the 2 screws holding shifter boot assembly. Pull… Read More
How To Install Agency Power Weighted Shift Knob | VW GTi | Golf R
This Install Guide is intended to help with the installation of the Agency Power Weighted Shift Knob for 2010-2019 VW GTi and 2015-2019 Golf R. Remove the shifter boot. Push the 2 locking tabs forward and pull up on bezel. Using a small screw driver place in the loop of the strap… Read More
How To Install Agency Power Lightweight Under-Drive Crank Pulley on VW GTi
This Install Guide is intended to help with the installation of the Agency Power Lightweight Under-Drive Crank Pulley on the Volkswagen 2.0L TSI Engine. 2014-2019 Audi A3 / S3 1.8 TSI / 2.0 TSI 2014-2019 Audi TT / TTS 1.8 TSI / 2.0 TSI 2015-2019 VW GTi 2015-2019 VW Golf 1.8 TSI… Read More
How To Install Agency Power Lightweight Under-Drive Crank Pulley on VW 2.0L TDI
This Install Guide is intended to help with the installation of the Agency Power Lightweight Under-Drive Crank Pulley on the Volkswagen 2.0L TDI Engine. 2015-201 Audi A3 (8P) 2015-2019 VW Golf 7 Sedan & SportWagen 2015-2019 VW Beetle 2015-2019 VW Jetta VI 2015-2019 VW Passat Remove passenger side lower fender liner. Using… Read More
How To Install Agency Power Hood Latch for Ford Focus
This Install Guide is intended to help with the installation of the Agency Power Hood Latch on the 2012 – 2018 Ford Focus All Models Including ST / RS. Remove the factory hood latch cable. Remove a few of the push pins holding radiator shroud to support. This will allow access to the hood… Read More
