Category Archives: Technical Support
How to Install Porsche 991 Turbo Intercoolers
Agency Power Porsche 991 Turbo or Turbo S Intercooler Installation Professional Installation is highly recommended Step 1: Remove the rear bumper, taillights, and both factory intercooler mounting brackes & ducts. Step 2: Remove the foam seal on the plastic lower intercooler air duct and trim the highlighted area shown in Figure A.… Read More
Agency Power PDK Upgraded Steering Wheel Installed in Porsche Panamera Turbo
We have been working closely with our partner in Germany to create some top notch steering wheels for Porsche, BMW and more. These wheels are made using the existing OEM Steering Wheel core and are completely configurable down to the color of the stitching. This paticular Agency Power PDK steering wheel was… Read More
How to Install Agency Power Aeroform Rear Diffuser | BMW F80 M3 & F82 M4
This DIY guide is intended to help with the installation of the Agency Power Aeroform Carbon Fiber Rear Diffuser for BMW F82 F80 M4 M3 2015-2016 The following is recommended for installation: 3M Automotive Double Side Tape 8mm socket/nut driver 50:50 isopropyl alcohol and water Clean Microfiber towel Friend to assist PLEASE… Read More
How to Install Agency Power Aeroform Front Lip | BMW F80 M3 & F82 M4
This DIY guide is intended to help with the installation of the Agency Power Aeroform Carbon Fiber 3 Piece Front Lip for BMW F82 F80 M4 M3 15-16 The following is recommended for install: 3M Automotive Double Side Tape 8mm socket/nut driver hex/Allen wrench set 50:50 isopropyl alcohol and water Friend to… Read More
How to Install Agency Power Aeroform Side Skirt Extensions
This DIY guide will help guide you with the installation of the Agency Power Aeroform Side Skirt Extensions. STEP 1: Jack up and support the car using jack stands. You will need to have plenty of clearance under the side skirt in-order to remove them. Please do not attempt to work under… Read More
How to Install The Carbon Fiber Rally Wing on Subaru Hatchback WRX STI
This DIY guide will help you with the installation of the VR Aero Carbon Fiber Rally Wing for the 2008-2014 Subaru WRX & STI Hatchback. Tools Required: 10MM Deep Socket 3″ or 4″ Extension Small Flat Head Screwdriver Phillip Screw Driver Other: 3M Double Sided Tape Friend to assist Step #1: Order… Read More
