Category Archives: Technical Support
Can-Am Maverick X3 Turbo Upgraded Intercooler Installation
This guide is to help with the installation of the Agency Power Upgraded Intercooler for the Can-am Maverick X3 Turbo | DS | RS & RC Estimated Install time: 30-45 min Step 1: Remove the intake and intercooler plastic covers from the rear of the X3. Step 2: Remove the two 2x… Read More
How To Install Agency Power Infiniti Q50 Catback Exhaust System
This guide is to help with the installation of the Agency Power Catback Exhaust for Infiniti Q50. Install Level: STEP 1 – Unbolt the 4 factory bolts from down-pipes to X-pipe. STEP 2 – Unbolt the 4 factory bolts from mid-pipes to the muffler. Remove the hangers from bushings on the factory muffler… Read More
Can-Am X3 Modular Gauge Pod Installation
This guide to help with the installation of the Agency Power Can-am X3 Modular Gauge Pod Step 1: Remove the 4x torx screws from the dash bezel Step 2: Pull the gauge slightly out from the housing and disconnect the electrical harness from the back of the gauge. Step 3: Remove… Read More
How to Install Agency Power Cold Air Intake System on Subaru BRZ / Scion FR-S / Toyota 86
This Install Guide is intended to help with the installation of the Agency Power Cold Air Intake Kit on the 2013-18 Subaru BRZ / Scion FR-S / Toyota 86. INSTALL DIFFICULTY: STEP 1 – Unclip the Mass Air Flow Sensor Harness and then loosen the 2 screws. Remove the Mass Air Flow Sensor.… Read More
How to Install Agency Power Catback Exhaust System on Ford Focus RS
This guide is to help with the installation of the Agency Power Catback Exhaust for Ford Focus RS. Install Level: STEP 1 – Locate the OEM Exhaust valve module at the rear of the exhaust system next to the driver side exhaust tip. Disconnect the valve and remove the 3 nylon locking nuts… Read More
Can-Am X3 Turbo Intake Instructions
This guide is to help with the installation of the Agency Power Can-Am Maverick X3 Turbo Intake. STEP 1 – Remove the plastic intake cover, intercooler vent, and engine access cover. STEP 2 – disconnect the breather hose from factory air box. STEP 3 – Loosen the hose clamps on the intake… Read More
