Category Archives: Install Guide
Can-Am X3 Big Injector Installation by Agency Power
This guide is to assist with the installation of the Agency Power Big Injector Upgrade for the Can-Am Maverick X3 Turbo. These are 1065cc at 3bar fuel pressure. Designed to be used with standard unleaded fuel. Tuning is required to maximize the performance of your Can-Am X3. Step 1: Remove the two… Read More
Agency Power Upgraded Camshafts Installation for the Can-Am X3
We hope you have found this link as a new purchaser of our Camshafts for your Can-Am Maverick X3 Turbo. These are a direct drop in and will take you about 6 hours to do the install with the proper tools. These installation steps are showing you what was done to swap… Read More
How to Install Agency Power Handbrake Kit for Can-Am Maverick X3
With this quick guide, you can add a hydraulic handbrake to your Can-Am Maverick X3. Handbrakes are not only fun, but they can help position the X3 near the limit. We recommend this handbrake for experienced drivers only. This product is intended for off-road use only. We recommend checking all components for… Read More
In-Depth Tech Guide to the Can-Am Maverick X3 Turbo Upgrade
We sit down with the complete Agency Power Maverick X3 turbo upgrade and go through the parts and show you how the kit bolts together. The Can-Am Maverick X3 Turbo has revolutionized the UTV world with its performance capabilities. After you have done all the basic bolt-on modifications, the next biggest gain… Read More
How to Install Agency Power Aluminum Door Handles for Can-Am Maverick X3
With this quick guide, you can easily replace the finicky factory Maverick X3 door straps with easy-to-use Agency Power aluminum latches. Only basic tools are required to get this job done. Install Difficulty Estimated Install Time 15-30 Minutes Per Door Parts Right Latch Arm Bracket Right Handle Bracket Left… Read More
How To Install Agency Power Hidden Hood Scoop Light Bar Mounting Brackets for 2014+ Toyota Tundra
This install guide is to help aid the installation of Agency Power part #AP-TUN-910. Level of difficulty: Remove the trim piece off the front of the hood by locating and removing the three bolts underneath and pull trim straight off. Flip the trim piece around and begin to disassemble the factory hood… Read More
