Agency Power Porsche Turbo Throttle Body and Plenum Install Instructions
1.) Place couplers onto Plenum as far in-board as possible. Insert left side (driver side) first. Rotate counter clockwise into position. Slide Couplers out into place and secure with clamps.
2.) Install Vacuum lines to plenum. Install Throttle Body to plenum with provided bolts
3.) Place couplers on y-pipe as far on as possible. Remove bolt from AC Line bracket on power steering pump (loose lines needed). Adjust AC Line slightly up.
4.) Lay Y-Pipe into position. Place left side air intake box into MAF housing. Rotate air box clockwise. Lift right side of Y-Pipe. Push Right Side of Air Box and Right Side of Y-Pipe into place simultaneously. For Agency Power Y-Pipes, consider removing air shock from right side of trunk lid.
5.) Connect Y-Pipe coupler to Throttle Body and secure with clamps. Connect and secure intercooler and Y-Pipe with couplers and clamps. Connect AC line bracket to power steering pump with bolt. Make sure everything is tight and secure.
6.) This is the location for the check valve