Agency Power Carbon Fiber Porsche Panamera Turbo Y-Pipe–ACCEPTING ORDERS NOW!
AGENCY POWER CARBON FIBER PORSCHE PANAMERA TURBO Y-PIPE:
From the NEW AP Carbon Division, comes the Carbon Fiber version of our wildly successful aluminum Y-Pipe Kit for the Porsche Panamera Turbo! We wanted to step up the luxury look of the engine bay with a full carbon fiber version. This carbon fiber Y-Pipe is a full replacement and includes everything you need to install in place of the original.
The stock Y-Pipe is a 2 piece plastic Y design that is smooth on the inside with a “deflector” internally to channel air. The bad part about the stock one is it goes from a 78mm ID at the throttle body down to a approximately 51mm diameter Y split. This then connects to rubber boost hoses that expand under pressure. Both of these are a power robbers! If you retain the stock design and stock diameter hoses, YOU CANNOT GAIN power no matter if the YPipe is cast aluminum or plastic. This is why we made a complete Y-Pipe kit which retains a 3inch diameter design all the way to the factory end piece connections at the intercoolers.
The dyno sheet shows the car in standard mode with the stock Y piece versus our big Y-Pipe kit. These are huge gains throughout the ENTIRE rpm band which is impressive. Dyno proven results are not something to see, but something you can feel. The more airflow you get into that throttlebody the more HP you will gain. By eliminating the rubber boost hoses, you remove the pressure fluctuation from expansion which loses power. With our Y-Pipe kit, the air flow improvement improves every aspect of driving your Panamera Turbo. As tested on our Mustang AWD Dyno, the Y-Pipe made 34awhp and 35ft/lbs of torque.
These Y-Pipes are all made in the USA using carbon fiber braided sleeve and a bladder molding technique. The Y-Pipe includes necessary couplers and clamps for a true bolt on installation. All clamps should be torqued to no more then 15lbs. These are designed for the 2010 and up Porsche Panamera Turbo.
For Pricing and more information, visit here
When is this gonna be available for the cayenne. That’s what I wanna know. There’s a market for it. Let’s do it.
Unfortunately, this has been discontinued some time ago.
How much to come out of retirement and make one of these again? You must have the mould / jig measurements ? Even in a different material. Please let me know.
We unfortunately will not be manufacturing these intakes though Agency Power. Our sister company Vivid Racing does have a few options and might be manufacturing this same intake in the future, but as of right now I am not sure when that will take place.