Agency Power’s new AP Carbon division is up and running!  We will be designing and making our own line of Carbon Fiber Products in house, in the USA!

Stay tuned(and subscribe!) to our Blog, Twitter, YouTube, and Facebook Fan Page for a full in depth Feature on AP Carbon soon!!

In the meantime, here is a sneak peek at the first AP Carbon part, the Carbon Fiber Porsche Panamera Y-Pipe!

PRODUCT DESCRIPTION FROM OUR ALUMINUM PORSCHE PANAMERA Y-PIPE :  “Looking at the stock Y design in front of the throttle body, we new there was improvements to be made. This throttle body is the same size as the Cayenne TT throttle body we use on our 996TT and 997TT upgrade kits. The stock Y-Pipe is a 2 piece plastic Y design that is smooth on the inside with a “deflector” internally to channel air. The bad part about the stock one is it goes from a 78mm ID at the throttle body down to a approximately 51mm diameter Y split. This then connects to rubber boost hoses that expand under pressure. Both of these are a power robber! If you retain the stock design and stock diameter hoses, YOU CANNOT GAIN power. This is why we made a complete Y-Pipe kit which retains a 3inch design all the way to the factory end piece connections at the intercoolers.

The dyno sheet shows the car in standard mode with the stock Y piece versus our big Y-Pipe kit. These are huge gains throughout the ENTIRE rpm band which is impressive. Dyno proven results are not something to see, but something you can feel. The more airflow you get into that throttlebody the more HP you will gain. By eliminating the rubber boost hoses, you remove the pressure fluctuation from expansion which loses power. With our Y-Pipe kit, the air flow improvement improves every aspect of driving your Panamera Turbo. As tested on our Mustang AWD Dyno, the Y-Pipe made 34awhp and 35ft/lbs of torque.”

Below is a short video showing the strength of the AP Carbon: