Your car is not only a performance machine, but a show winner. When opening the hood for fellow enthusiasts, having a stand out engine bay will gain great respect and clinch for awards. In addition to style, the all new Agency Power silicone radiator hoses have a function. The 3 piece radiator hose kit features a 5ply design to replace all your major coolant hoses. The silicone radiator hoses are more durable, more resistant to cracking from heat, and easier to clean. These Agency Power silicone radiator hoses are a great addition to your engine bay and will fit on all 2013+ Scion FR-S / Toyota GT-86 / Subaru BR-Z.

Hoses are available in red, black, or blue only.

Tools Needed:

• Agency Power Silicone Hoses
• Socket wrench
• 10mm socket
• 12mm socket
• plier
• hose clamp removal tool (recommended)
• bucket or drain pan equivalent
• Subaru Blue coolant (2-3 gallons if not re-using stock)
• Jack & jack stands or lift
• flathead
• sandwich or food equivalent

Install Guide:

1. Start by purchasing your Agency Power Silicone Radiator Hoses for you FRS,BRZ, or GT86 from www.agencypower.com or one of our many great dealers all over the world.
2. Remove the radiator cap by turning counter clockwise. (*NOTE: DO NOT ATTEMPT THIS UNLESS THE VEHICLE IS COLD, HOT COOLANT MAY RESULT IN BURNS) 
3. Start by lifting the vehicle by either a shop lift or jack up the car by the specified jacking points.
4. Then begin removing the front plastic splash guard, it is secured by a few 10mm bolts and plastic fasteners.
5. Once the plastic is removed you will see the yellow radiator drain valve on located on the passenger side of the vehicle.
6. Place you drain pan or bucket underneath the valve and turn counterclockwise. 
7. While the coolant is draining, this is good idea to grab your sandwich and enjoy. The drain process will take about ~10min.
8. Once the steady stream of coolant has slowed to a drip, it is okay to close the valve.
9. Move over to the driver side of the vehicle and begin removing the lower radiator hose clamps. (*Note: the upper clamp is difficult to access)
10. Once both clamps are removed, place you coolant catcher below and remove the factory hose by twisting and pulling.
11. Once the remainder of coolant has been expelled, replace the factory hose with the new Agency Power Silicone hose.
12. Secure the new hose with the supplied clamps.
13. At this time, check that bleeder valve is closed and you may begin to put the plastic splash guard back on.
14. Lower the vehicle to a desired working position.
15. Start removing the upper 2-piece radiator hose on the passenger side  of the vehicle. (*Note: We found it easiest to remove the (2) 12mm bolts that secure the radiator fill neck)
16. Secure the new hoses with the supplied clamps and recharge the cooling system with the Subaru Blue coolant.
17. Burp the system if needed.
18. Turn the vehicle on, let idle for 5-10 min and check for leaks.
19. Enjoy your new Agency Power radiator hoses!